5 Motives Seat Keys Replacement Is A Good Thing

Seat Alhambra Key Problems

Seat’s jumbo family MPV is among the best in class in terms of retaining resale value. With a new model on sale, the Jumbo family MPV is more impressive.

There are a myriad of reasons that the key fob may not function properly, including a dead battery water damage, receiver module problems or signal interference. This article will walk you through the steps to fix it.

Water Damage

If your seat ibiza car key replacement alhambra key fob is able to withstand the wash cycle or a bath in the ocean or pool then it probably has an incredible waterproof chip, but do not make it a habit because exposure to water in excess increases the risk of the key fob getting damaged. If the key fob ceases to working after exposure to clean tap water or rain, simply take out the battery, clean the electronic component using a paper towel and allow it to dry completely before putting the battery back in. If the key fob was exposed to soapy or salty water, it is recommended that you clean the chip with isopropyl or electronic cleaner.

Faulty Receiver Module

If the key fob will not lock or unlock after having replaced the battery in the button cell It is possible that the receiver module has a fault. The good news is that it is a fairly easy and inexpensive repair, you can simply disconnect the 12 volt battery for about a couple of minutes (first take off the negative cable and then press the horn button multiple times) to drain any residual electric current, then reconnect it in reverse order e.g. Positive first, then negative.

ESP Warning Light – If the ESP warning symbol flashes this is normal and means that the vehicle is driving on terrain where the traction between the road surface and the tyres isn’t ideal, such as snow, gravel or lots of surface water. If the ESP warning light continues to be flashing, it means there is a fault within the system and should be diagnosed using a iCarsoft i908 Seat OBD Code Reader kit that will provide you with a specific fault description.

Dead Coin Battery

A dead battery for the coin is one of the most common reasons for the seat alhambra keys to stop working. The key fob has tiny button cell batteries which keeps it powered. Replace it with a brand new battery with the same size, voltage and specifications as the original. If you’re replacing the battery ensure that you remove all metal retaining clips from the back of the key fob and ensure that the contacts are clean and free of corrosion.

If the key fob was exposed to water (such as soapy or rain tap water), it is recommended that you remove and clean the chip with an electronic cleaner or isopropyl ethanol before installing a brand new battery. The chip is sensitive to moisture and could be permanently damaged. If the key fob still isn’t working after replacing the battery it could be necessary to replace the key fob.

Faulty Receiver Module

If your key fob stopped working after replacing the battery but it didn’t perform, or stopped working in a sudden manner, your receiver module could have developed a problem. The receiver module is responsible to receive the radio frequency signals sent by your remote key fob, and converting them into electrical commands that are then used by other modules in the car.

If the receiver module has developed a fault it will not respond to any of the commands issued by your remote key fob. In this situation the dealer will have to reprogramme the key fob as well as install an additional receiver.

The key fob is fitted with rubber seals that stop water from entering the chip inside. However, if you submerge your key fob into salted or soapy ocean water, the chip inside could be damaged. You can try to clean the chip by rub it with isopropyl alcohol or electronic cleaner, but in the event that your key fob doesn’t work after doing this, you’ll have to purchase a replacement.

If the keys are paired but the receiver module has developed a fault, you can try rebooting all of the electronics on board by disconnecting the battery that is 12 volts for a few minutes. Then, reconnect the battery in reverse order (negative cable first and then positive). This will reset the onboard electronic and restore their functionality.

Electronic chip that is malfunctioning

The key fob houses a small electronic chip which transmits a signal the receiver module each time the key is used. If the signal does not match the one the car has stored, the immobilizer will disable and prevent the vehicle from starting. If the key fob does not work and you are unable to reprogram it, this could be due to an issue with the microchip.

The chip inside the key fob could need to be altered to allow it to function again. The best way to do this is to remove the key from its housing and then using a pin or needle to connect with each of the metal clips that hold it. If they are corroded or damaged, you’ll have to replace them to allow the remote control to function. Make sure that any replacement seat key batteries have the same size, voltage, and specification as the original.

The Seat Ibiza Key Programming Alhambra is an attractive and well-designed model however, like all cars it may encounter issues with particular components or equipment. A few owners have reported issues with the climate control system that is automatic. It is prone to fail and get stuck in a particular setting. The infotainment systems can also malfunction and freeze the screens.

Leave a Reply